Mass Flow Controllers

Tylan Mass Flow Controller Model FC-280. Flow Rate 10 SLPM of O2, Eliminates air convection currents inside its case without sacrificing response speed. Can be mounted in any position without requiring zero adjustment. Assures accuracy over the entire range of mass flow controller. Easily removed for range changes. Completely compatible with reactive and corrosive materials. Design eliminates internal dead volumes. Eliminates the need for complex, interactive multi-point linearisation during calibration.

Brooks Instruments Quantim Coriolis mass flow meter/controller, Model Number QMAC003KDA1CDMCDABAFA0A

Most accurate measurement and control for very low-flow applications.

Flow Range (Full Scale Capacity)  13,500 gm/hr (Water @ 1 bar pressure drop), 27,000 gm/hr (maximum)

Can be used for liquids and gas. Hardware configuration. Valve: NC, seat: Kalrez, Seal: Nickel/Kalrez, fitting 1/8"VCR to 1/4"swagelok. Orfice: 0.007". Software DSP firmware 1.06, Application XB04. set point Parameter: mass Flow.

Can be calibrated for any type of liquid etc. Supports HART communication protocol. Revision #5. Hart 4-20 ma. Max flow 3000 gm/hr

Mass Flow Meter/Controller, Max pressure 10500 psig, 200 SCCM, Gas: Nitrogen, P1:100-200 psig, P2:0-120 psig

Mass Flow Meter/Controller, Max pressure 1500 psig, 1000 SCCM, Gas: Methane, P1:60-150 psig, P2:0-120 psig

Mass Flow Meter/Controller, Max pressure 1500 psig, 500 SCCM, Gas: Oxygen, P1:60-150 psig, P2:0-120 psig

Brooks Instruments Quantim Coriolis mass flow meter/controller, Model Number QMAC003KDA1CDMCDABAFA0A

Can be used for liquids and gas. Hardware configuration. Valve: NC, seat: Kalrez, Seal: Nickel/Kalrez, fitting 1/8"VCR to 1/4"swagelok. Orfice: 0.007". Software DSP firmware 1.06, Application XB04. set point Parameter: mass Flow.

Can be calibrated for any type of liquid etc. Supports HART communication protocol. Revision #5. Hart 4-20 ma. Max flow 3000 gm/hr

Tylan Mass Flow Controller Model FC-280. Flow Rate 100 sccm of CL2, Eliminates air convection currents inside its case without sacrificing response speed. Can be mounted in any position without requiring zero adjustment. Assures accuracy over the entire range of mass flow controller. Easily removed for range changes. Completely compatible with reactive and corrosive materials. Design eliminates internal dead volumes. Eliminates the need for complex, interactive multi-point linearisation during calibration.

Sierra Side Tark III Mass Flow Controller, Range 0 to 200 SLPM, Pmax 500 psi, 0.215 orifice, 0 to 5 VDC output.

Sierra Mass Flow controller, Large Volume Type, Model 741-1, Max flow 400 M3/Hr (Air), Operating voltage supplied. Controlling voltage: 0 to 5 VDC